Note: If the clutch components have slipped or the disc cage has been lifted, the large - and if necessary the small - disc cage should be inserted into all inner discs with light rotational movements by hand. In particular, make sure that the clutch housing cover is always installed in the same position as it was when the "new" clutch was delivered.
1. Retaining ring: determine new thickness
2. Large disc cage: do not remove
3. Double-disc clutch housing: with the "K2" clutch installed
4. Sealing ring: 4 pcs.
5. Outer disk: 4 pcs.
6. Inner disk: 4 pcs.
7. Adjusting washer
8. Retaining ring: If the retaining ring has been removed to re-install the discs, it must be replaced with a new ring of the same thickness
9. Clutch housing cover
10. Retaining ring: replace; do not install deformed retaining rings
(The original article can be found on the resource: SKODABOOK)