Contents: All ⬇ Installation ⬇
Remove the air filter housing assembly if it interferes with access to the clutch hydraulic lines. Remove the battery and battery bracket.
All
Caution! Risk of brake fluid leakage. When performing the following work, make sure that no brake fluid gets on the side members or the gearbox. If this happens, the area must be thoroughly cleaned. Place a lint-free cloth under the master cylinder.
Clamp hose "2" for operation after shutdown to the master cylinder using the hose clamp -MP7-602 (3094)-.
Note: If the after-run hose is pinched with the hose clamp -MP7-602 (3094)-, it will be deformed. However, the after-run hose remains functional. After removing the hose clamp -MP7-602 (3094)-, if necessary, return the after-run hose to its original working condition.
Pull the clamp on the clutch master cylinder hose line out as far as it will go and remove the hose line. Plug the holes. Pull the clamp "A" out as far as it will go and disconnect the clutch slave cylinder hose line "B". Plug the holes.
-Arrows- do not take into account. Seal open pipes and connections with clean plugs from the plug set for the engine "VAS 6122". Release and remove the hose line.
Installation
Installation in reverse order. Connect the hose line "1" to the master and slave cylinders of the clutch. To check, pull the line. After removing the hose clamp -MP7-602 (3094)-, if necessary, return the hose for operation after switching off "2" to its original working condition. Install the battery bracket and battery.
[Article posted on the website www.SKODABOOK.ru]