1. Mounting bracket
2. Bowden cable
3. Adjusting nut
4. Fixing screw
5. Handle for unlocking the hood lock
Removing
1. Pull the hood release lever towards you (1), to open the hood.
2. Install a flat screwdriver in the gap between the hood release lever (1) and retaining ring (2), shown in the figure below.
3. Remove retaining ring (2) from the hood release lever (position 1) (arrow) and disconnect the lever from the support bracket (3), as shown in the figure below.
Note. Before starting work on the support bracket (3) remove the lower part of the trim panel of the center pillar (4).
Installation
1. Install retaining ring (2) on the hood release lever.
2. Install and press the release lever (1) hood cover to support bracket (3), shown in the figure below.