Locking the hydraulic tensioner of the timing chain (engine 1.2 MPI) (Skoda Rapid NH1)
Press the tensioner plunger (2), acting through the guide rail (1), and move it inside the housing until the holes in the plunger and the housing coincide, as shown in the figure below. Then install the walking rod (B) in the holes or a special lock (T40011) rod diameter 3 mm).
This article is available at russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian
Article verified: Anatoly Ovchinnikov
Read similar articles on other Skoda models
➧ Starting a gasoline engine Skoda Fabia 1 (1999-2007)
➧ Timing chain casing parts and assemblies Skoda Octavia 3 (2013-2019)
➧ Removal and installation valve N205 and timing chain covers (engine… Skoda Superb 2 (2008-2015)
➧ Upper timing chain cover Skoda Kodiaq 1 (2016-2024)
➧ Removal and installation the timing chain and oil pump drive chain Skoda Yeti (2009-2017)
➧ Removal, checking and installation the front cover, timing chain and… Skoda Felicia (1994-2001)
Link to this article in various formats
Reviews and comments of visitors
No comments yet
- General information
- Faults en route
- User manual
- Maintenance and care
- Power unit
- Petrol engines
- Diesel engines
- Power and control system
- Lubrication system
- Cooling system
- Intake and exhaust system
- Transmission
- Clutch
- Mechanical gearbox
- Automatic gearbox
- Drive shafts
- Chassis (running gear)
- Front suspension
- Rear suspension
- Brake system
- Steering
- Body and interior
- Exterior (external elements)
- Interior (internal elements)
- Doors, locks and windows
- Heating and air conditioning
- Security systems
- Electrical equipment
- Equipment and devices
- Power devices
- Electrical circuits
- Electrical circuits (petrol)
- Electrical circuits (diesel)