Front seat belts
1. For installation details of the front seat belts, refer to Ref. illustrations. References in this subsection refer to this illustration.
20.1 Installation details of the front seat belts
1 Height adjuster
2 Bolt, 22 Nm
3 Top anchor
4, 8, 10 Bolt, 35 Nm
5 Guide, bolted 6
6 Bolt, 3 Nm
7 Belt buckle
9 Return mechanism with emergency tensioner
11 Bottom anchor, fastened with a bolt 10
2. To remove the height adjustment assembly (1) remove the B-pillar top trim (see Section 17), remove the bolt (4), remove the top anchor (3) and remove the bolt (2).
3. To remove the return mechanism (9) disconnect the negative cable from the battery, remove the upper and lower C-pillar trim panels (see Section 17), remove the top and bottom anchors (3 and 11), disconnect the emergency tensioner squib connector and remove the bolt (10). Turning out the bolt causes blocking of the return mechanism, and when the bolt is tightened, the blocking is removed.
Rear seat belts
4. Details for installing the rear seat belts are shown on Ref. illustrations. References in this subsection refer to this illustration.
20.4 Rear seat belt installation details
1 Side belt return mechanism
2, 6 Bolt, 35 Nm
3 Center belt recoil mechanism
4 Nut, 35 Nm
5 Double buckle
7 Belt buckle
8 Bottom anchor
5. To remove the return mechanism (1) side belt remove the side trim of the luggage compartment (see Section 18) and remove the bolt (2).
6. To remove the return mechanism (3) center belt tilt the rear seat, partially raise the floor covering of the luggage compartment and remove the bolt (6) castle (7). Remove the rear seat cushion (see Section 19), remove the backrest upholstery and give the nut (4).
7. To remove the lock (7) or bottom anchor (8) fold the rear seat, partially raise the luggage compartment floor and remove the bolt (6 or 4) respectively.