Contents: SRS control unit ⬇ Side impact sensor (by pressure) ⬇ Side impact sensor (by acceleration) ⬇
Note: Before working on SRS components, be sure to disconnect the battery cables (see Chapter 5) and wait at least three minutes after that. After installing the SRS components, first turn on the ignition and then connect the battery.
SRS control unit
1. Turn on the ignition and disconnect the negative battery cable (see Chapter 5).
2. Remove the side trims of the center console (see Chapter 11).
3. Unlock the lock (2 in the illustration) connector (3) in the direction of the arrow of the SRS unit (1), loosen the nuts (4) and remove the control unit.
13.3. Removing the SRS control unit
4. Installation is carried out in reverse order. Tighten the nuts to 9 Nm. If a new SRS unit is installed, it must be programmed.
Side impact sensor (by pressure)
5. Turn on the ignition and disconnect the negative battery cable (see Chapter 5).
Data taken from an online portal skodabook.ru
6. Remove the front door trim (see Chapter 11).
7. Disconnect the connector (2 in the illustration), press the locking tab in the direction of the arrow with a screwdriver (1) and remove the sensor (3).
13.7. Removing the side impact sensor (by pressure)
8. Installation is carried out in reverse order.
Side impact sensor (by acceleration)
9. Turn on the ignition and disconnect the negative cable from the battery (see Chapter 5).
10. Remove the lower pillar trim from the body (see Chapter 11).
11. Disconnect the connector (2 in the illustration), unscrew the bolt (1) and remove the sensor (3).
13.11. Removing the side impact sensor (by acceleration)
12. Installation is carried out in reverse order. Tighten the bolt to 9 Nm.