Note: Before installation, check and ensure that the steering gear boots are not damaged.
Tightening torques for threaded connections
| Bolts for fastening the front suspension subframe assembly to the body Always replace the mounting bolts after disassembly | 70 Nm + additionally tighten by 180° |
| Steering gear mounting bolts to front suspension subframe Always replace the mounting bolts after disassembly | 70 Nm + additionally tighten by 90° |
| Fastening the tie rod end to the steering knuckle When tightening the fastening nut, hold the hinge pin from turning | 20 Nm + additionally tighten by 90° |
| Connecting bolt of universal joint and steering gear pinion shaft Always replace the mounting bolts after disassembly | 20 Nm + additionally tighten by 90° |
| Fastening the anti-roll bar to the front suspension subframe Always replace the mounting bolts after disassembly | 20 Nm + additionally tighten by 180° |
| Thermal insulation coating for the steering gear housing | 8 Nm |
| Fastening the strut to the anti-roll bar When tightening the fastening nut, hold the hinge pin from turning | 65 Nm |
| Mounting the vehicle height sensor stand to the front lower control arm | 8 Nm |
| Fastening the lower arm of the front suspension to the ball joint of the steering knuckle | 100 Nm |
| Wheel mounting bolts | 120 Nm |