Release coolant hose "2". Unlock the clamps "arrows", remove the upper part of the air duct "1".
Disconnect electrical connector "2" from mass air flow meter "G70". Disconnect vacuum hose "4". Loosen hose clamp "3", remove air hose. Remove air filter "1".
Installation
Installation in reverse order.
Note: The nozzles, pipes and hoses of the supercharging system must be degreased before installation. Use silicone-free grease to install the air pipes. Only use approved spring clamps to secure the hose connections.
Disconnect the drain hose "arrow". Clean the branch pipe, the lower part of the air filter and the hose from dirt and leaves.
When connecting the intake manifold pipe to the air filter housing, observe the mounting marking "arrows". Install the air filter on the battery bracket and press until it clicks into place. Press the air filter again and then pull it back to check if the latches have clicked into place correctly.
