Contents: Removal and installation of the…⬇ Installation ⬇ Tightening torque ⬇ Removal and installation the boost…⬇ Tightening torque ⬇
Removal and installation of the boost pressure regulator "V465"
Turn off ignition. Disconnect connector "1". Disconnect lock washer "2" using centering pin "T40265". Unscrew screws "arrows" and remove boost pressure regulator "V465".
Installation
Installation in reverse order. Adapt the engine control unit "J623" to the boost pressure regulator "V465".
Tightening torque
Removal and installation the boost pressure sensor "G31" / intake air temperature sensor 2 "G299"
Disconnect connector "1". Disconnect the "arrow" clips and remove the boost pressure sensor "G31" / intake air temperature sensor 2 "G299".
Installation
Installation in reverse order.
Note: Replace the sealing ring. If the fasteners break during removal, the sensor can be secured with screws.
Tightening torque
(Data copied from the portal: SKODABOOK.ru)