Contents: Installation ⬇ Upper Oil Pan - Torque and…⬇
Remove the air conditioning compressor from the bracket and tie it up. Remove the oil pump.
Loosen in sequence -19...1- and completely unscrew the screws. Carefully separate the upper part of the oil pan from the gluing areas. Remove the oil separator.
Installation
Note: Replace the screws that are tightened to the specified angle. Replace the sealing rings, gaskets and self-locking nuts.
Check the oil passages in the upper part of the oil pan and in the cylinder block for contamination. Clean the mounting surfaces from oil and grease.
Note: The sealant must not be expired (see expiration date).
Cut off the tip of the tube of sealant at the mark located on its end (the hole diameter should be approximately 2 mm).
Caution! Risk of clogging the lubrication system due to excess sealant. The sealant layer thickness must not exceed the prescribed one.
Apply a bead of sealant "arrow" to the cleaned seating surface of the upper part of the oil pan, as shown in the figure. Thickness of the sealant bead: 2...3 mm.
Note: After applying the sealant, the upper part of the oil pan must be installed within 5 minutes.
Check the reliability of the installation of the centering pins "2" in the cylinder block. Install the oil separator "1" in the cylinder block. Install the upper part of the oil pan and tighten the mounting screws.
Upper Oil Pan - Torque and Tightening Sequence
Note: Replace screws that are tightened to the specified angle.
Tighten the bolts in stages in the specified sequence.
Installation in reverse order. Install the oil pump. Install the air conditioning compressor. Fill the engine with oil and check its level.