Contents: Tightening order of the screws…⬇ The order of tightening the screws…⬇ Tightening order of the screws…⬇
Tightening order of the screws securing the lower part of the oil pan, made of plastic
Note: Replace screws that are tightened to the specified angle.
Tighten screws -1 through 20- in 2 stages in the sequence shown.
1. Tighten the screws to a torque of 8 Nm.
2. 90° (turn ¼ turn further.)
The order of tightening the screws that secure the lower part of the oil pan, stamped from a thin sheet metal
Note: Replace screws that are tightened to the specified angle.
Tighten screws -1 through 20- in 2 stages in the following sequence:
Article posted on the website (SKODABOOK.ru)
1. Tighten the screws to a torque of 8 Nm.
2. 45° (turn ⅛ turn further.)
Tightening order of the screws securing the upper part of the oil pan
Note: Replace screws that are tightened to the specified angle.
Tighten screws -1 through 14- in the sequence shown.
1. Tighten screws -1 to 14- to 8 Nm
2. Screws -1 and 2 - turn 180° (½ turn)
3. Tighten screws 3 through 9 by 45° (⅛ turn)
4. Tighten screw "10" 180° (½ turn)
5. Tighten screws 11 through 14 by 90° (¼ turn)