Removing
1. Remove the key from the ignition lock and turn off all electrical consumers.
2. Remove the additional storage compartment for small luggage from the dashboard on the front passenger side.
3. If installed, the damper cover must be removed from the ventilation fan.
4. Disconnect the wiring harness connector (2), shown in the figure below.
5. Release the wiring harnesses from the clamps (1) And (2), as shown in the figure below.
6. Disconnect the wiring harness connector (4) and remove from the cover of the electric motor of the fan of the ventilation system (5), as shown in the figure below.
7. Unscrew the screws shown in the figure below (arrows). Tightening torque when installing 1 Nm.
8. Tilt the left side of the fan housing towards you, turn gently to the left and remove the assembly as shown in the figure below.
9. Using a flat screwdriver with a narrow sting, press on the tabs (2) locking the wiring harness connector in the direction of the arrows, then disconnect the wiring harness connector (1), by pulling downwards as shown in the figure below.
10. Squeeze on the grips (3) inside and remove the screwdriver.
11. Remove the fan motor together with the impeller from the holder.
Installation
Installation is carried out in the reverse order of removal.
Note.
- The wiring harness connector should click into place.
- Before installation, check and make sure that the fan is working.