2. Remove the rear seat back assembly (see the corresponding section in Chapter Body).
3. Remove the upper part of the luggage compartment trim panel (see the corresponding section in Chapter Body).
4. Unscrew the mounting bolt (1) shown in the figure below. Tightening torque of the mounting bolt during installation: 40 Nm.
5. Remove the lower seat belt anchor (2) from the main support surface (3) as shown in the figure below.
6. Unscrew the mounting bolt (1) shown in the figure below. Tightening torque of the mounting bolt during installation: 40 Nm.
7. Remove the automatic retractor (2) from the upper part of the rear body panel as shown in the figure below.
Installation
1. Installation is carried out in the reverse order of removal.
(Data taken from this portal: www.skodabook.ru)