Contents: Removal ⬇ Installation ⬇
Removal
1. Disconnect the negative terminal (4) from the battery, as shown in the figure below.
2. While holding the cover (3) open, loosen the positive battery terminal (2) fastening nut as shown in the figure below.
3. Carefully squeeze the clips (arrow A) using a screwdriver, disconnect and move the fuse box together with the positive terminal (1) to the side, in the direction of arrow B, as shown in the figure below.
4. Unscrew the mounting bolt (1) shown in the figure below.
5. Remove the mounting bracket (2).
6. Remove the battery (3) from the support (4) as shown in the figure below.
Installation
1. Installation is carried out in the reverse order of removal.
Install the battery so that the protrusions in the holder (arrows) touch the battery, as shown in the figure below.
The battery is installed correctly if the middle notch on the front bottom plate matches the hole in the battery holder "arrows".
Attention.
- If the battery is not installed correctly or is not secured tightly, the following hazards may occur:
- Reduced durability due to vibrations (explosion hazard).
- Damage to battery plates.
- Damage to the battery box through the mounting plate (possible acid leakage, increased subsequent costs).
- Insufficient safety in case of an accident.