Removing
Attention.
- In case of improper removal, the holders of the decorative engine cover on the cylinder head cover may break off.
- Therefore, all the instructions below must be observed.
1. Release the decorative engine cover gradually in the marked sequence (1...4) from attachment points. To do this, grasp the engine cover in the places indicated by the arrows from below, as far as possible and pull it out of the mounts in an upward direction, as shown in the figure below.
Installation
Attention. Before proceeding with the installation of the engine cover, it is necessary to check the correct position of the 4 fasteners (spherical inserts) and, if necessary, insert them again into the correct position. Otherwise, the engine cover would be damaged.
1. Press, if necessary, the spherical liners of the engine casing into the correct positions.
2. With the top engine cover in place on the fasteners, press it in the corners until it clicks into place.