1. Vacuum pump for brake booster
2. Intake camshaft control valve
3. Fuel injector for cylinder #1
4. Fuel injector for cylinder #2
5. Cylinder #3 fuel injector 6. Cylinder #4 fuel injector
7. Brake booster system pressure sensor
8. Electronic engine control unit
9. Hall sensor
10. Transmission neutral position sensor
11. Turbocharger bypass valve
12. Lambda sensor after catalytic converter
13. Lambda sensor
14. Ignition coil with external power stage, No. 4
15. Ignition coil with external power stage, No. 3
16. Ignition coil with external power stage, No. 2
17. Ignition coil with external power stage, No. 1
1. Knock sensor 1 -G61-
2. Throttle valve assembly -J338- (when replacing, delete the specified parameters)
3. Charge pressure sender G31- with intake air temperature sender 2 -G299
4. Intake air pressure sender -G42- and intake air temperature sender -G71-
5. Fuel pressure regulating valve -N276-
6. Solenoid valve 1 for activated charcoal tank -N80-
7. Engine coolant pump -V50 -
1. Solenoid valve for boost pressure control -N75 - (connected to the turbocharger)
2. Hydraulic oil pressure drop switch -F1-
3. Coolant temperature sender -G62-
4. Fuel pressure sender -G247-
5. Engine speed sender -G28-
1. O-ring (replace, lightly lubricate with clean engine oil before installation)
2. Elastic part (replace after each removal of the lower part of the intake manifold, observe the correct location on the fuel injector)
3. Fuel injector for cylinder 4 -N33-; Fuel injector for cylinder 1 -N30-; fuel injector for cylinder 2 -N31-; Fuel injector for cylinder 3 -N32- (with Teflon seal and support ring, after removing the fuel injector, the Teflon seal and support ring must be replaced)
4. Intake manifold - bottom (To remove, remove and install throttle valve control unit -J338- and intake manifold)