Note.
- Necessary special devices, control and measuring devices, as well as auxiliary means:
- Socket wrench - Т10370-.
Removing
Note. The installation location of the engine speed sender G28- is located under the intake manifold on the flange gasket on the gearbox side.
1. Disconnect the wiring harness connector (1) from the engine speed sender -G28- as shown in the figure below.
2. Remove the seal shown in the figure below (2) Remove engine speed sender -G28- from engine block using socket wrench -T10370- as shown in figure below.
Installation
1. Install engine speed sender -G28- and tighten retaining screw to 5 Nm.
2. Next, the installation is carried out in the reverse order of removal.