Removing
1. Remove the oil pan (for details, see the relevant section in this chapter).
2. Unscrew the fastening bolts (4), shown in the figure below, then remove the oil receiver assembly (3).
3. Unscrew shown in the figure below (arrows), mounting bolts and remove the oil deflector plate (2).
4. Disconnect the oil pump assembly (1) from the drive toothed belt, then remove the pump completely.
Installation
Installation is carried out in the reverse order of removal.
Note. The O-rings must always be replaced after disassembly.
Before installation, it is necessary to check the presence of guide pins in the oil pump housing (arrows), which are shown in the figure below. If the pins are missing, they must be installed, since without them it will not be possible to center the position of the pump.
Check and make sure that the oil pump rotates smoothly and without sticking, and that there are no extraneous noises when it rotates.
Check the technical condition of the drive toothed belt. Replace the belt if it gets any oil products.
Beeci and n meshing the pump sprocket with the drive belt, install the pump assembly and tighten the bolts of its fastening together with the oil slinger plate.
Install oil pan assembly (for details, see the relevant section in this chapter).