Removing
1. Remove the top decorative engine cover.
2. Remove the crankcase ventilation hose (1), shown in the figure below, for which you should press the unlock buttons.
3. Release suction hoses (arrows), shown in the figure below.
4. Disconnecting the hose clamp (3). Disconnect the air pipe from the air filter housing.
5. Unscrew the fastening screw (2), fold the air intake sleeve with the intake pipe back and disconnect from the turbocharger, as shown in the figure below.
6. Unscrew the fastening screws (2) And (3), remove the engine lug (1) as shown in the picture below.
7. Disconnect the wiring harness connector (arrow), shown in the figure below.
8. Unscrew oil pressure drop switch -F1-.
Installation
Installation is carried out in the reverse order of removal.
Note. Replace sealing ring.
Install the inlet pipe.
Install the vacuum line.