Appearance
1. Cover, installation torque 25 Nm
2. O-ring
3. O-ring
4. O-ring
5. Insert
6. Oil cooler/cooler
7. Mounting bolt, installation torque 11 Nm
8. Seal
9. Mounting bolt, tightening torque when installing 15 Nm + tighten an additional 90° (¼ turn)
10. Oil filter holder
11. Seal
To replace the oil filter
Squeezing the vacuum lines out of the clamps (arrows), put them aside.
Oil filter holder, tightening torques and order
Note. Replace the oil filter holder screws.
Install the top left and bottom right screws first.
Tighten the screws in two steps.