2. Unscrew the filling plug (level control) gear oil (arrow), as shown in the figure below.
3. If the gearbox is filled with the required amount of oil, then the level of the latter reaches the lower edge of the oil filler hole.
4. Tighten the oil filler screw (arrow) with the required tightening torque.
In the case of a new charge, the following instructions must be observed:
Unscrew the oil filler screw (arrow), shown in the figure above.
Top up with gear oil up to the lower edge of the oil filler hole.
Screw in the oil filler screw (arrow).
Start the engine, engage a gear and crank the gearbox for approx. 2 minutes.
Stop the engine, remove the oil filler screw (arrow).
Top up gear oil again up to the lower edge of the oil filler hole.
Tighten the oil filler screw (arrow) with the required tightening torque.
Install the lower engine cover assembly (for details, see the relevant section in chapter Body).
Various versions of the oil filler plug and the oil drain plug.
- I - Filler plug or oil drain plug with internal polyhedron: 24 Nm.
- II - Filler screw or oil drain plug with hexagon socket: 32 Nm.