Simos 2P and Magneti-Marelli 1AV systems and precautions The Simos 2P and Magneti-Marelli 1AV systems belong to the family of closed-loop motor control systems. Such systems control both direct fuel injection and fuel ignition. This Part of the Chapter is devoted only to the...
Removing and installing the air cleaner assembly Removing Air cleaner assembly components (models 1.6 l) 1 - Screws for fastening the cover of the throttle body; 2 - Throttle housing cover; 3 - Receiving knee of the air supply sleeve; 4 - Breather pipe; 5 - Sealing...
Intake air temperature controller The intake air heating control system consists of a temperature-sensitive plate valve installed inside the air cleaner housing and a heated air supply hose from the heating device housing installed above the exhaust...
Removing, installing and adjusting the accelerator cable Removing 1. Remove the cover installed on the throttle body (see Section Removing and installing the air cleaner assembly ). 2. On the throttle body, disconnect the cable core from the throttle spindle plate - the core...
Removal and installation of components of the Simos 2P injection system Note. See the warnings in Section General information and precautions . For the connection diagram of the MPFI components, see Section Removal and installation of components of the Magneti-Marelli 1AV injection system ....
Removal and installation of the fuel tank Note. See the warnings in Section General information and precautions . See Section Removal and installation of the fuel tank .
Removal and installation of the inlet pipeline Note. See the warnings in Section General information and precautions . Removing Relieve the pressure in the fuel tank (see Section Release of residual pressure in the power system ), then disconnect the negative cable...