Central fuel injection (SPFI) Skoda Felicia

Description of the Mono-Motronic design and precautions
Functional diagram of the Mono-Motronic system 1 - Ignition switch; 2 - Battery; 3 - Crankshaft speed and position sensor; 4 - λ-probe; 5 - Catalytic converter; 6 - Carbon adsorber; 7 - Evaporative Emission Control...

Removal and installation the air cleaner assembly
Air Cleaner Assembly Components 1 - Air cleaner top cover; 2 - Filter element; 3 - Intake air temperature control valve-switch; 4 - Sealing gasket; 5 - Air cleaner housing; 6 - Mounting plate; 7 - Vacuum capsule; 8 -...

Vacuum switch for intake air temperature control
Removal 1. Remove the air cleaner housing (see section Removal and installation the air cleaner assembly ). 2. Disconnect the remaining vacuum tube from the vacuum switch(going to the vacuum capsule of the valve-switch...

Removal, installation and adjusting the accelerator cable
Removal 1. Remove the air cleaner housing (see section Removal and installation the air cleaner assembly ). 2. At the throttle body, disconnect the cable core from the throttle spindle plate - the core should be pulled...

Removal and installation components of the Bosch Mono-Motronic system
Electrical connection diagram of the components of the Bosch Mono-Motronic system 1 - From terminal 15 of the ignition switch; 2 - λ-probe; 3 - Crankshaft speed sensor; 4 - Coolant temperature sensor; 5 - Throttle...

Removal and installation the fuel pump and fuel flow sensor assembly
Note: See the warnings provided in Section General information and precautions . Avoid contact of fuel with exposed skin - use protective gloves. Perform work only in a well-ventilated area. General information The fuel...

Removal and installation the fuel tank
Removal Note: See the warnings provided in Section General information and precautions . 1. The fuel tank does not have a drain plug, so it is advisable to dismantle it after it is completely empty. Do not forget to...

Relief of residual pressure in the fuel system
Note: See the warnings provided in Section General information and precautions . This procedure only relieves pressure in the fuel system. Fuel will remain in the system and components - be prepared to collect traces of...

Removal and installation the intake manifold
Intake manifold components 1 - Throttle body support flange; 2 - Mounting bolt; 3 - Inlet manifold; 4 - Intake manifold mounting nut; 5 - Cooling system hose going to the heater; 6 - Injection system coolant temperature...

Checking the operation and adjusting the injection system
1. In case of malfunction of the injection system, first of all, it is necessary to check the condition and reliability of fastening of contact connections of the corresponding electrical circuits. Then check the...

Unleaded Fuel — General Information and Rules of Use
Note. The information provided in this Chapter is fair at the time of writing these Guidelines and applies only to fuel grades used in the United Kingdom. Please consult the representatives of the company's Skoda...

This section is available on russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Link to this section in various formats

TEXTHTMLBB Code

Felicia (1994-2001)