Car steering Skoda Felicia

Removal and installation the steering wheel
Note: If the vehicle is equipped with a driver's airbag, the steering wheel hub cap will have the word "AIRBAG" stamped on it. Models not equipped with airbag Removal 1. Set the front wheels of the vehicle in a...

Removal and installation the steering column
Note: On models equipped with a driver's airbag, the appropriate precautions must be taken (see Chapter On-board electrical equipment ). Removal 1. Disconnect the negative cable from the battery. 2. Remove the steering...

Steering column overhaul
Steering Column Components 1 - Clamp; 2 - Assembly of steering column switches; 3 - Receiver socket; 4 - Steering column switch lever; 5 - Upper casing; 6 - Bolt; 7 - Lower casing; 8 - Steering wheel; 9 - Nut (35 Nm);...

Removal and installation the ignition switch/steering wheel lock assembly
Castle assembly Note: New shear screws will be required during reassembly. Removal 1. Disconnect the negative cable from the battery. 2. Complete the procedures in paragraphs 1 through 5 of Section Removal and...

Removal, repair and installation of the steering gear
Steering gear assembly 1 - Seal; 2 - Screw (7 Nm); 3 - Spring washer; 4 - Crankcase cover; 5 - Sealing ring; 6 - Sealing gasket; 7 - Adjusting washers; 8 - Ball bearing; 9 - Gear; 10 - Toothed rack; 11 - Bushing; 12 -...

Replacing the rubber protective covers of the steering gear housing
1. Remove the appropriate tie rod end (see section Removal and installation outer tie rod ends ). 2. Mark the installation position of the protective boot on the steering gear housing and tie rod, then release the...

Removal air locks from the hydraulic circuit of the power steering system
1. The need to carry out this procedure arises only after disconnecting the components of the hydraulic tract. 2. Remove the filler cap of the steering pump reservoir and add the required amount of fresh hydraulic fluid...

Removal and installation the steering pump
Removal 1. Firmly set the parking brake, then jack up the front of the vehicle and support it on stands. 2. Loosen the bolts securing the drive belt pulley to the steering pump, then loosen the belt and remove it from...

Removal and installation outer tie rod ends
Note: You will need a ball joint puller to perform this procedure. Removal 1. Set the parking brake, then jack up the front of the vehicle and support it. Remove the appropriate front wheel. 2. If the tip does not need...

Removal and installation the steering rod
Note: A special key (Skoda #MP7-601) is required to disconnect the inner tie rod end from the rack and pinion mechanism. The key is inserted into a secure engagement with the tie rod end housing, which allows the rod to...

This section is available on russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Read similar sections on other Skoda models

➧ Chassis (running gear): Steering Skoda Fabia 1 (1999-2007)
➧ Chassis (running gear): Steering Skoda Rapid 1 (2012-2022)
➧ Chassis (running gear): Steering Skoda Octavia 3 (2013-2019)
➧ Chassis (running gear): Steering Skoda Superb 2 (2008-2015)
➧ Chassis (running gear): Steering system Skoda Kodiaq 1 (2016-2024)
➧ Chassis (running gear): Steering Skoda Yeti (2009-2017)

Link to this section in various formats

TEXTHTMLBB Code

Felicia (1994-2001)