Gearbox Specifications Type - Mechanical 5-speed gearbox, all forward gears are synchronized Gear ratios 1st - 3.308:1 2nd - 1.913:1 3rd - 1.267:1 4th - 0.927:1 5th - 0.717:1 Reverse - 2.923:1 Main gear: Wagon and Pickup models - 4.167:1 All...
General description of the gearbox The transmission mechanisms are enclosed in an aluminum alloy crankcase that is bolted to the left end of the engine. The transmission consists of a differential. main gear and gearbox. Drive is transmitted from the...
Shift rod — removal, reassembly and installation Pic. 7.1. Traction/Shifter Components 1. Stabilizer rod for gear shifting; 2. Upper cover of the stabilizer bar; 3. Gear lever; 4. Protective cover of the gear lever; 5. Gear lever handle; 6. Bottom protective cover; 7....
Speedometer drive — removal and installation Removing 1. Working in the engine compartment, unscrew the knurled retaining ring that secures the speedometer drive cable to the drive mechanism located at the rear of the transmission, disconnect the cable (see...
Replacing oil seals in the gearbox Drive shaft oil seal 1. Block the rear wheels of the vehicle, apply the handbrake, then jack up the front of the vehicle and place it on axle stands. Remove the front wheel. 2. Drain the gear oil as described in Section...
Reversing light switch — service check, removal and installation Health check 1. The reversing light circuit is controlled by a plunger-type switch screwed into the bottom wall of the transmission case. If there is a malfunction in its circuit, first check for blown lamps or circuit...
Transmission — removal and installation Removing 1. Disconnect the negative cable from the battery. 2. Remove the starter as described in Section 12 . 3. Working in the engine compartment, turn the clutch cable adjusting nut counterclockwise to obtain maximum...