Gearbox Specifications Common parameters Gear box type Manual, five-speed (5 forward gears and one reverse), with full synchronization of all forward gears gear ratios 1st gear 1:3.308 2nd gear 1:1.913 3rd gear 1:1.267 4th gear 1:0.927 4th...
Description of components and mechanisms of the gearbox Section of the RKPP 1 - Carter (dome) clutch; 2 - Gearbox housing; 3 - Primary shaft; 4 - Cover; 5 - Bearing 30205; 6 - PLC 05-12 bearing; 7 - Secondary shaft; 8 - Driven gear of the main gear; 9 - Bearing 32005; 10 -...
Removal and installation of drafts of a drive of a gear change Removing Note. Reassembly will require a new roll pin for the selector rod. 1. Park the vehicle on a level, level surface, if possible paved. Firmly apply the parking brake, then jack up the front of the vehicle and...
Replacing gearbox seals Drive shaft seals Note. Reassembly will require a new circlip securing the driveshaft inboard joint. 1. Apply the parking brake and chock the rear wheels. Jack up the front of the car and place it on jack stands. Remove...
Check, removal and installation of the sensor-switch of reversing lights Examination 1. The operation of the reversing lights is controlled using a plunger-type sensor-switch screwed into the base of the gearbox housing from above. In the event of a malfunction of the lights, first check the...
Removal and installation of the speedometer drive mechanism Removing 1. In the engine compartment, at the rear of the gearbox housing, find the speedometer drive device. loosen (but don't turn away) knurled union nut for fastening the drive cable. 2. Turn out a fixing bolt and...
Removal and installation of a transmission Removing Note. Reassembly will require new mounting bolt nuts as well as new circlips for the driveshaft inner pivots. 1. Support the rear wheels of the vehicle. Apply the parking brake, then jack up the front of the...