Fuel injection system car Skoda Favorit

Central petrol injection specifications
System type Engine Codes 135V and 136V - Bosch Mono-Motronic Fuel system data Fuel pump type - Electric, submerged in the fuel tank Fuel injection pump injection rate - 1000 cm³/min (at battery voltage of 12.5 volts)...

General description of the injection system
Bosch Mono-Motronic Engine Management System Diagram 1. Fuel filter; 2. Fuel tank filler neck; 3. Equalizing tank; 4. Fuel tank with electric pump; 5. Activated carbon filter; 6. Fuel vapor recirculation solenoid valve;...

Precautions when working with the injection system
Warning: Gasoline is extremely explosive - use extreme caution when working around the fuel system. Always keep a fire extinguisher close to the work site, read the rules for its use before starting work. Protect your...

Air Filter and Intake System Components — Removal and Installation
2.1 Air intake system with intake air temperature regulator and air filter 1. Lid; 2. Filter element; 3. Pneumatic switch; 4. Gasket; 5. Body; 6. Plate; 7. Air temperature control valve body; 8. Branch pipe; 9. Air...

Vacuum switch for adjusting the inlet air temperature — removal and installation
Removal 1. Remove the air cleaner housing as described in Chapter 2 . 2. Disconnect the hose from the vacuum switch, remembering its location. 3. Remove the bottom plate of the vacuum switch. 4. Remove the switch and...

Throttle cable — removal, installation and adjustment
Removal 1. Remove the air cleaner housing as described in Chapter 2 . 2. At the throttle body, disconnect the throttle cable from the throttle shaft plate, and separate the cable tip. 3. Remove the adjusting bracket and...

Bosch Mono-Motronic System Components — Removal and Installation
Note: When working with fuel system components, follow the precautions given in Chapter 1 . Throttle body Removal 1. Guided by Chapter 2 , remove the air filter housing. 2. Guided by Chapter 9 , depressurize the fuel...

Fuel pump and fuel level indicator sensor
Note: Before starting work, refer to the precautions in Chapter 1 . General information 1. The fuel pump and fuel level indicator sensor are combined into one unit, which is installed on top of the fuel tank. Access to...

Fuel tank — removal and installation
Note: Before starting work, refer to the precautions in Chapter 1 . Removal 1. Before removing the fuel tank, drain as much fuel as possible from it. 2. Disconnect the negative battery cable. Use a hand pump to suck out...

Fuel injection system — leak
Note: Before starting work, refer to the precautions in Chapter 1 . Warning: The following procedure simply relieves pressure in the fuel system. Remember that fuel is present in the system components. 1. The fuel...

Intake manifold — removal and installation
Note: Before starting work, refer to the precautions in Chapter 1 . Removal 1. Disconnect the negative battery cable. 2. Guided by Section 1 , drain the coolant from the engine. 3. Guided by Chapter 5 , remove the...

Fuel injection system — checking serviceability and adjustment
10.11. Intake manifold 1. Throttle body mounting frame; 2. Bolt; 3. Collector; 4. Nut; 5. Hose to the heater; 6. Temperature sensor (for engine management system); 7. Hose fitting to valve cover; 8. Brake booster hose...

This section is available on russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Link to this section in various formats

TEXTHTMLBB Code

Felicia (1994-2001)