Replacing bulbs in headlights General information In case of failure of any incandescent lamps, attention should be paid to the following points: a) Before replacing, disconnect the negative cable from the battery (see the remark given in Section...
Front position lights — bulb replacement 1. Turn the access cover counterclockwise and remove it from the back of the headlight. 2. Remove the side light bulb holder from the headlight, then remove the bulb from the bulb holder. 3. Installation is carried out...
Front fog lights — bulb replacement Note. The information below only applies to pre-1998 models. At the time of writing this manual, information on later models was not available. 1. Gently prying with a small screwdriver, remove the fog lamp cover from...
Front direction indicators — bulb replacement 1. Locate the direction indicator retainer in the front corner of the engine compartment. Release the latch and release the pointer assembly from the fender. To gain access to the right turn indicator, it may be...
Repeaters of forward indexes of turns — replacement of lamps 1. Reaching through the wheel arch, push the follower assembly out of the fender. 2. Release the cartridge from the lens assembly, then remove the bulb. 3. Installation is carried out in the reverse order. Track the...
Rear Combination Light Assembly — Bulb Replacement 1. In the luggage compartment of the car, release the clamps and remove the lamp holder assembly from the lamp. 2. All lamps are equipped with bayonet sockets and must be slightly recessed and rotated counterclockwise...
High Stop Light — Bulb Replacement 1. Release the latches and remove the lamp holder assembly from the back of the lamp. 2. Remove the lamp to be replaced from the holder. All lamps are equipped with push type sockets. 3. Installation is carried out in...
License plate light — bulb replacement Models Sedan and Hatchback 1. Using a small screwdriver, gently pry the light assembly out of the tailgate. 2. Release the lamp socket from the lamp lens, then remove the push-type lamp from the socket. 3. Installation...
Replacing interior lighting bulbs General information See paragraph 1 of Section Replacement of lamps of external lighting and signaling devices . Front saloon lamp 1. Gently prying with a screwdriver, release the lamp from the ceiling upholstery. 2....
Removal and installation of a headlight Note. Before starting work, do not forget to disconnect the negative cable from the battery (see the warning in Section General information and precautions ). Headlights 1. Remove both front direction indicators. 2. On...
Assemblies of forward indexes of turns — removal and installation 1. Locate the indicator assembly retainer in the front corner of the vehicle's engine compartment. Squeeze out the locking tab and release the pointer assembly from the vehicle fender. 2. Turn and remove the cartridge...
Front fog lights — removal and installation Note. The information below only applies to pre-1998 models. More recent data was not available at the time of writing this manual. 1. Using a small flat-blade screwdriver, carefully pry the fog light cover off the...
Repeaters of forward indexes of turns — removal and installation 1. Push the follower assembly out of the vehicle wing through the wheel arch. 2. Release the cartridge and remove the lens. 3. Installation is carried out in the reverse order. Track reliability of fixing of a lens of...
Assemblies of the rear combined lamps — removal and installation 1. Release the clips and remove the lamp holder assembly from the back of the lamp. 2. Give fixing nuts and remove assemblage of a lantern from the car (together with a seal) (see accompanying illustration). Check the...
Upper level brake light and license plate light Upper level stop signal 1. Turn out fixing screws and separate assembly of a stoplight from an internal wall of a door of a back. 2. Disconnect electroconducting and remove assembly from the car. 3. Installation is...
Adjusting the direction of the optical axis of the headlights General information Fine adjustment of the direction of the optical axis of the headlights can be made only with the use of special optical equipment in a service station. Approximate installation of the headlights can...