Fabia Rapid Octavia Superb Kodiaq Yeti Others

Kodiaq 1 (2016-2024)

Elements of the exhaust system (Skoda Kodiaq NS7)

0

Installation position of the mounting clamp

Install the hose clamp in the position shown in the figure below.

Angle α = approximately 20°

The tie bolt should be on the right side.

The mounting nut should be on top.

The mounting nut should be on top.

(Article posted on the website: «SKODABOOK»)

This article is available at russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Article verified: Eleonora Afanasyeva

Skoda Kodiaq 1: Intake and exhaust (petrol 1.4 l)

Intake manifold — removal and installation
Air filter — removal and installation

Catalytic converter assembly with exhaust pipe — removal and installation
Turbocharger — general view
Turbocharger assembly — removal and installation
Boost pressure regulator — removal and installation
Boost Pressure Sensor/Intake Air Temperature Sensor — removal and…

Read similar articles on other Skoda models

➧ Exhaust system — general information Skoda Fabia 1 (1999-2007)
➧ Elements of the power supply and control system (1.2 l TSI engine) Skoda Rapid 1 (2012-2022)
➧ Injection system — engine control by electronic elements Skoda Octavia 1 (1996-2004)
➧ Checking the condition of the exhaust system Skoda Superb 2 (2008-2015)
➧ Checking the condition of the exhaust system Skoda Yeti (2009-2017)
➧ Exhaust system checks Skoda Favorit (1987-1994)

Link to this article in various formats

TEXTHTMLBB Code

Reviews and comments of visitors

No comments yet

Kodiaq 1 (2016-2024)

By continuing to use the site, you agree to the use of cookies.