Engine oil pressure sensor for the pressure reduction line — removal and installation (Skoda Kodiaq NS7)

Removal

1. Remove the air filter housing assembly (for more details, see the relevant section in the chapter "Intake and exhaust system").

2. Disconnect the wiring harness connector (arrow) shown in the figure below.

Note: Place a rag under the pressure sensor to collect any leaking engine oil.

3. Unscrew the engine oil pressure sensor from the engine.

Installation

Installation is carried out in the reverse order of removal.

Note:

• Always replace the sealing rings after disassembly.
• Check the engine oil level in the engine. If necessary, add the required amount of oil to the engine.

Text taken from this website SkodaBook.ru