General appearance
1. Drain plug; 2. Sealing ring; 3. Oil filter cover, installation tightening torque 25 Nm; 4. Sealing ring; 5. Oil filter element; 6. Sealing ring; 7. Engine oil pressure sensor, tightening torque of the sensor during its installation is 20 N·m; 8. Mounting screw; 9. Oil filter housing with engine oil cooler; 10. Mounting screw; 11. Gasket; 12. Sealing ring; 13. Engine oil pressure sensor for the pressure reducing line, tightening torque during installation 20 N·m; 14. Sealing ring.
Oil filter housing, tightening torques and tightening sequence of mounting bolts
Note: After disassembly, it is always necessary to replace the mounting bolts, which must be additionally tightened to a certain angle.
- Install the upper left and lower right mounting bolts first.
First approach: tighten the mounting bolts in the sequence shown in the figure below with a tightening torque of 20 Nm.
The second approach: tighten the mounting bolts in the specified sequence by an additional 90' angle.
