Contents: Removal ⬇ Installation ⬇
Removal
1. Disconnect the negative terminal from the battery.
2. Compress the tabs (arrows) and remove the posts (1) to the right side, as shown in the figure below.
3. Turn the clutch release master cylinder rod so that the notches (1) and stud (2) are visible, as shown in the figure below. The samples (1) and pins (2) are directed in the same direction.
4. Remove the bushing (A) from the eye (1) as shown in the figure below.
Installation
1. Turn the clutch release master cylinder rod so that the notches (1) and stud (2) are visible, as shown in the figure below. The samples (1) and pins (2) are directed in the same direction.
2. Install the sleeve (A) into the eye (1) and turn it to the installation position.
3. Connect the clutch master cylinder rod to the clutch pedal, install a new axle bolt.
4. Connect the negative terminal to the battery.