Return spring and additional reinforcement spring (depending on the configuration) — removal and installation (Skoda Kodiaq NS7)

Removal

1. Disconnect the negative terminal from the battery.

2. If equipped, remove the driver side knee airbag module (1) as shown in the illustration below.



3. Unscrew the mounting bolt and remove the footwell ventilation duct (1) from the driver's side, as shown in the figure below (for more details, see the relevant section in the chapter "Ventilation, heating and air conditioning system").



4. Disconnect from the bracket and remove the universal diagnostic connector (1), shown in the figure below.



5. Unscrew the mounting bolt (2) and detach the deformable strut (1), as shown in the figure below. Then move the stand to the side.





6. Compress the clamps (arrows) and remove the axial connecting bolt (1) of the clutch release master cylinder rod, as shown in the figure below.



7. Move the clutch release pedal in the direction of arrow A and disconnect the return spring (1) from it, as shown in the figure below.

8. Move the clutch release pedal in the direction of arrow A, then remove the booster spring (2) shown in the figure below.

Installation

Installation is carried out in the reverse order of removal.

Note: Make sure that the bushings (arrows) of the support shafts (1) are installed in the clutch release pedal mounting bracket.

1. Move the clutch release pedals in the direction of arrow A - towards the passenger compartment.



2. Install the bolt (1) into the support (2) of the clutch pedal mounting bracket as shown in the figure below.

3. Install the bushing (3) into the support (4) of the clutch release pedal, as shown in the figure below.

Article posted on the website (skodabook.ru)

4. Press the clutch release pedal in the direction of arrow B and move it until the auxiliary booster spring moves toward the support.



5. Connect the clutch master cylinder rod to the clutch pedal using a new connecting bolt.



6. Install the deformable stand (1) and tighten its mounting bolt (2) to the required tightening torque, as shown in the figure below.



7. Install the universal diagnostic connector onto the mounting bracket.

8. Install the air duct for the footwell of the ventilation system on the driver's side (for more details, see the corresponding section in the chapter "Ventilation, heating and air conditioning system").

9. Install the driver's side knee airbag module (for more details, see the relevant section in the chapter "Passive safety").

10. Connect the negative terminal to the battery.