Contents: Removal ⬇ Installation ⬇
Removal
1. While working in the engine compartment, turn the clutch adjusting nut counterclockwise to obtain maximum cable play.
2. While working inside the cabin, move the floor carpet away from the top of the clutch pedal to gain access to the cable end.
3. Press the locking clip and separate the cable from the upper end of the pedal.
4. Using pliers, detach the spring from the clutch pedal.
5. To obtain the space required to remove the clutch pedal, it is necessary to lower the steering column (see Chapter 14 Section 10).
6. Remove the retaining bracket from the right end of the pedal pivot shaft. Move the clutch pedal to the left to disengage it from the bracket and remove the pedal from under the dashboard (see photo). Note that the clutch pedal pivot bushing is also the brake pedal pivot shaft. Therefore, if the bushing must be removed, insert a suitable screwdriver into the right end of the retaining bracket to hold the brake pedal in the operating position.
 |
 |
Installation
7. Install in the reverse order of removal, applying a thin coat of multi-purpose grease to the pivot pin and pedal bushing. Finally, adjust the clutch cable length as described in Section 1.