| State | Possible reasons | Action |
| Clutch slippage | Clutch master cylinder Clutch slave cylinder Clutch pressure plate Clutch driven disc Leaks of oil or working fluid from the engine or gearbox housing in the block with the drive axle | Check the technical condition and, if necessary, repair |
| Vibration or rough clutch engagement | Engine and gearbox mounts in a block with a drive axle | Check the technical condition and, if necessary, repair |
| Clutch pressure plate Clutch driven disc Flywheel | Check the technical condition and, if necessary, repair | |
| Clutch grabbing | Insufficient brake fluid | FILL the brake fluid reservoir to the maximum mark. INSPECT the brake and clutch hydraulic systems for leaks. REPAIR if necessary. |
| Air in the hydraulic clutch system | BLEED the clutch system. | |
| Clutch pedal free play Clutch pressure plate Clutch driven disc Crankshaft axial clearance | Check the technical condition and, if necessary, repair | |
| Difficulty shifting gears | Clutch grabbing. | Check the technical condition and, if necessary, repair |
| Adjusting the gear shift cable | CHECK the shift cable adjustment. | |
| External controls | CHECK external controls for wear or damage. If necessary, INSTALL new components and parts. | |
| Gear wheels. | DISASSEMBLE the gearbox in the block with the drive axle. If necessary, INSTALL new components and parts. | |
| Gear selection mechanism | DISASSEMBLE the gearbox in the block with the drive axle. If necessary, INSTALL new components and parts. | |
| Synchronizer. | DISASSEMBLE the gearbox in the block with the drive axle. If necessary, INSTALL new components and parts. | |
| Increased noise | Insufficient damping of engine vibrations. | Check the technical condition and, if necessary, repair |
| Low transmission fluid level in the gearbox in the block with the drive axle. | CHECK the transaxle for leaks. FILL with transmission fluid. | |
| The engine or gearbox in the block with the drive axle touches the chassis or body. | Check the alignment of the powertrain/gearbox mounts in the block with the drive axle. | |
| Increased noise | Engine and gearbox offset in the block with the drive axle. | Check the alignment of the powertrain/gearbox mounts in the block with the drive axle. |
| External controls | CHECK external controls for wear or damage. If necessary, INSTALL new components and parts. | |
| Gears and bearings. | DISASSEMBLE the gearbox in the block with the drive axle. If necessary, INSTALL new components and parts. | |
| Clutch pedal. Clutch release bearing. | Check the technical condition and, if necessary, repair | |
| oil loss | Clutch master cylinder. Clutch slave cylinder. Clutch hydraulic lines. | Check the technical condition and, if necessary, repair |
| Axle shaft seal. | INSTALL a new axle shaft seal. | |
| Fluid leak between the sections of the gearbox housing in the block with the drive axle. | DISASSEMBLE the gearbox and axle assembly and clean the mating surfaces. CHECK mating surfaces for damage. SEAL the gearbox in the block with the drive axle with sealant. |
The original article is located on (SkodaBook)