Repair of brake caliper C 57
Note: When carrying out repairs, install the complete repair kit. Use only alcohol to clean the brake system. Lightly coat brake cylinder, piston and O-ring with lithium grease -G 052150 A2-.
1. Dust cap
2. Bleeding port, 10 Nm: Before screwing in, lightly coat thread with lithium grease -G 052150 A2-
3. Bolt, 35 Nm: replace after each removal
4. Guide pin
5. Seal: install in the groove of the brake shield and guide pin, lubricate the groove first, use a package of grease from the repair kit
6. Brake shield with guide pins and protective caps: installed together with guide pins and protective caps, lubricate the pins with a sufficient amount of grease, supplied as a spare part; in case of damage to the cuffs or guide fingers, install a repair kit (use the supplied grease pack to lubricate the guide pins)
7. Protective cap: do not damage when installing the piston
8. Pistons
9. O-ring
10. Brake caliper
FS-III brake caliper repair
When performing repairs, install the complete repair kit. Use only alcohol to clean the brake caliper. Lightly coat brake cylinder, piston and O-ring with lithium grease -G052150A2-.
1. Dust cap: put on the bleed screw
2. Bleeding port, 10 Nm: Before screwing in, lightly coat thread with lithium grease -G 052150A2-
3. Bearing sleeve: insert into brake caliper
4. Guide pin, 30 Nm
5. Protective caps: insert into the support sleeve
6. Brake caliper
7. O-ring
8. Pistons: Lubricate pistons with lithium grease -G 052 150 A2- before fitting
9. Protective cover: do not damage when installing the piston