1. Attachment bracket
2. Bolt, 3 pcs: different lengths; replace after disassembly; tightening torque: short screw, 20 Nm and tighten by 45° (⅛ vol.), long screw, 20 Nm and tighten by 180° (½ vol.)
3. Toothed pulley injection pump
4. 95 Nm: When loosening and tightening, use stop -T10051-
5. Hub: use puller-T10489- to remove
6. High pressure fuel pump: with fuel metering valve -N290- (Don `t open); After replacement, re-adjust the adaptation values in "Guided Functions"
Carefully! The injection pump must not operate in dry friction mode. If the injection pump has been removed or replaced, the fuel system must be filled with fuel and air removed from it before the first start of the engine.
7. Fuel supply line
8. Return hose
9. High pressure pipeline: between injection pump and fuel rail; observe all instructions for the installation of high-pressure piping