Engine installed
Insert counter support -MP1-223 (3067) - into the hole in the cylinder block.
Mounting position of the counter support
A. For tightening
B. For unscrewing
Engine removed
Place flywheel stopper -MP1 -504- on flywheel ring gear and rotate crankshaft until stopper rests on bushing -T30010-.
Vehicles with dual mass flywheel
Turn the secondary side -A- of the dual-mass flywheel so that the screws -B- are centered in the holes -see Fig. arrows-.
Carefully! When releasing screws -8-, make sure that the screw heads do not remain on the secondary side -A- of the dual-mass flywheel, as this could cause damage.
All
Loosen screws and remove flywheel.
Installation
Installation in reverse order.
Note: Use new screws for fastening.
Vehicles with dual mass flywheel
Turn the secondary side -A- of the dual-mass flywheel until the screws -B- are centered in the holes -see Fig. arrows-.
All
1. Screw in all screws by hand.
2. Tighten all screws crosswise to 60 Nm.
3. Tighten all screws in a 90°cross pattern (¼ vol.).