Note: The accelerator pedal module uses connectors that can be disconnected and connected in different ways.
Disconnecting connector 1KQ 973 706
Lightly press the gate -A- (grey) in -direction of arrow 1- and slide as far as it will go in -direction of arrow 2-. While holding the slider in this position, detach the connector housing -B- upwards in -direction of arrow 3-. The slider -A- remains in the lower position.
Connecting connector 1K0 973 706
Push connector housing -B- downwards in -direction of arrow- until it clicks into place. The slider -A- automatically moves to the top position. Check that the connector is secure by pulling it in the opposite direction.
Disconnecting connector 8K0 973 706
Pull out the slider -A- (Red) up to the stop in the direction of the arrow 1 -. Press slider in -direction of arrow 2- and detach connector housing -B- by pulling upwards in -direction of arrow 3-.
The slider -A- remains in the upper position.
Connecting connector 8K0 973 706
Push connector housing -B- down as far as it will go in -direction of arrow 1-. Lightly press the slider in -direction of arrow 2- and move downwards in -direction of arrow 3-. The slider -A- can only be moved down if the connector housing has been pushed down as far as it will go. Check that the connector is secure by pulling it in the opposite direction.