1. Press the brake pedal to the stop and fix it in this position.
2. Insert special tool (T10159A) and pull it towards the driver's seat while holding the brake pedal with your hand, as shown in the figure below (the brake pedal must not move backwards when performing an operation). Thus, the stop petals (3) mounted on the head of the vacuum booster rod (2), as shown in the figure below.
3. Pull special tool (T10159A) together with the brake pedal towards the driver's seat (thus, the pedal will be disconnected from the rod of the vacuum brake booster).
4. Install the ball head of the vacuum booster rod against the support in the brake pedal. Then press the brake pedal until a characteristic click indicates that the rod is fixed on the pedal, as shown in the figure below.
5. Check and make sure that the brake pedal is properly connected to the vacuum booster rod.