Removing
1. Remove front door trim panel (for details, see the relevant section in this chapter).
2. Remove the door cover (for details, see the relevant section in this chapter).
3. Remove the door lock cylinder (if the driver's door) or remove the door handle cover (if the passenger door) (for details, see the relevant section in this chapter).
4. Remove the door handle (for details, see the relevant section in this chapter).
5. Unscrew the fastening screw (4) and remove the gasket (3), as shown in the figure below.
6. Remove mounting bracket (1) out of the door by pulling it in the direction of the arrow «A», as shown in the figure below.
7. Disconnect the Bowden cable. For this:
Unlock bracket (5) and, turning, remove the support from the bracket. as below picture (arrow b).
Raise the control cable bolt in the direction of the arrow «With», as shown in the figure below.
Disconnect control cable (2) from mounting bracket (1). pulling it in the direction of the arrow «d», as shown in the figure below.
Installation
1. Installation is made in reverse order to removal.
2. Install the mounting bolt (2) and tighten it with a tightening torque of 1.5 Nm.