Removing
1. Remove front door trim panel assembly (for details, see the relevant section in this chapter).
2. Remove front door glass assembly (for details, see the relevant section in this chapter).
3. Remove the power window servo motor (for details, see the relevant section in this chapter).
4. Loosen the fastening nuts (3), shown in the figure below.
5. Disconnect drive ram clamps (arrow d), then push it inside the door body.
6. Move the power window mechanism inside the door body (1), by gently turning it in the direction of the arrow «A», as shown in the figure below.
7. Remove the power window mechanism through the service holes in the door (arrow b) And (arrow with), as shown in the figure below.
Installation
1. Install the power window mechanism (2) through the service hole in the door (arrow a), as shown in the figure below.
2. Set the power window mechanism inside the door to its mounting position (arrow b).
3. Install the power window mechanism studs through the door body to the outside (arrow with), then install and tighten the fastening nuts (4), as shown in the figure below. The tightening torque of the fastening nuts during installation is 8 Nm.
4. Press on the drive drum (1), to fix it in clamps (arrow d), as shown in the figure below.