Removing
1. Remove front door trim panel (for details, see the relevant section in this chapter).
2. Fix the door glass using adhesive tape to prevent it from falling inside the door.
3. Disconnect the wiring harness connector (4), shown in the figure below.
4. Unscrew the fastening screws (2), as shown in the figure below.
5. Remove the power window servo motor (1) from support bracket (3), as shown in the figure below.
Installation
Attention. When installing a new servo motor together with the control unit, initialization must be performed.
1. Install the front door glass servo motor (1) on support brackets (3), as shown in the figure below. Raise the window all the way and then lower it so that the gearing between the motor shaft and the drive drum is properly established.
2. Install and tighten the fastening screws (2) with a tightening torque of 3 Nm.