Removing
Note. The lock cylinder is installed only in the driver's door.
1. Remove plugs (4) And (6), shown in the figure below.
2. Unscrew the fastening bolt (5), as shown in the figure below.
3. Completely unscrew the fastening bolt (7), so that the door lock cylinder can be removed.
4. Pull the door handle (2), shown in the figure below.
5. Remove the lock cylinder housing (1) from mounting bracket (3), at an angle and in the direction of the arrow «b», as shown in the figure below.
Installation
1. Pull the door opening handle shown in the figure below (2), in the direction of the arrow «A».
2. Install the lock cylinder body (1) at a certain angle - in the direction of the arrow «0» - in the mounting bracket (3), as shown in the figure below.
3. Install and tighten the mounting bolts (5) And (7), applying a tightening torque of 3.5 Nm.
Note. When fastening the lock cylinder body with bolts, it must be pressed against the front door panel.
4. Further installation is carried out in the reverse order of removal.