Note: The information contained in the memory is not erased when the ignition is turned off or when the wires are disconnected from the battery.
2. When replacing parts installed at the factory, use only original and high-quality parts.
It is prohibited to use airbag parts taken from another car. Replace parts only with new ones
3. Carefully inspect all SRS components before installing them. If any of the airbag system components falls or if cracks, dents or other defects appear on the module housing, bracket or wire connector, replace them with new ones.
4. Before removing any parts of the passive restraint system, always disconnect the SRS connector.
5. Do not attempt to disassemble the airbag modules, as they do not have any maintenance-ready components. Once the airbag is activated, it cannot be repaired or reused.
When storing airbags, observe the following requirements:
Store the removed airbag with the outer trim facing up.
Avoid exposing the airbag modules to water or other liquids as this may cause damage.
Keep the airbag module away from heat sources.
(Information presented on the website SKODABOOK)
Do not perform any tests on the airbag wiring such as resistance testing.
During repairs, inspections or replacements, you should position yourself in such a way as to not be in the airbag area.
Avoid possible impacts to the passive safety system module and to the impact sensor area when the ignition is on. Turn off the ignition and wait three minutes before performing any work on the passive safety system.
When carrying out work, be careful not to cause accidental impact (when using wrenches, hammers and other tools) in the area where the passive restraint system module and crash sensors are located, as this may result in accidental deployment of the airbags and cause injury and damage
After an accident that triggered the front airbags, replace the airbags and the Passive Safety Control Unit (SRS). After a collision, when the side airbags are activated, replace the side airbag, the front and side collision sensors on the required side, and the passive Safety Control unit (SRS). After a collision when the front or side airbags fail. Check the Passive Safety System Control Unit (SRS) and the side impact sensors for damage or deformations. If there is no damage, replace the Passive Safety System (SRS) control unit and the front and / or side impact sensor.
Do not disassemble the SRS control module, front and side impact sensors.
Turn off the ignition, disconnect the negative battery terminal, and wait three minutes before installing or replacing the Passive Safety System (SRS) control unit.
Make sure that there is no liquid or oil on the surface of the Passive Safety System (SRS) control unit, the front and side collision sensors, and clean them from dust.
Store the Passive Safety System (SRS) control unit, front and side collision sensors at a temperature of 15-25°C and a relative humidity of 30-80%.
Note: Some security systems have spring-loaded latches.
Replacing components of the safety system after the airbag has deployed
If the front airbag deploys after a collision, replace the following components:
- Security System Control Module
- Airbags deployed.
- Seat belt pretensioners.
- Front impact sensor.
- Security system wiring harnesses.
If the seat belt pretensioner has deployed after a collision, replace the following components:
- Seat belt pretensioner.
- Security system control module.
- Front impact sensor.
- Security system wiring harnesses.
If the side and curtain airbags are deployed, replace the following components:
- Security system control module.
- Airbags deployed.
- Side impact sensor on the trigger side.
- Security system wiring harnesses.
After the vehicle has been fully repaired, make sure that the airbag system is working properly. Turn on the ignition, the airbag indicator should come on for six seconds and go out.