Removing
1. Remove the fuel pump (for details, see the relevant section in this chapter).
2. Unlock and disconnect wiring harness connectors (1) (black), (2) (blue) And (3) (brown), shown in the figure below.
3. Pressing the retaining tabs (arrows), pull out the measuring device of the fuel gauge (G) up as shown in the figure below.
Installation
1. Install the measuring device of the fuel gauge (G) into the grooves on the fuel pump, push it down until it locks into place as shown in the figure below.
2. Connect fuel lines (1), (2) And (3), fix them in the retaining slots as shown in the figure below.