Removing
Note.
- Necessary special devices, control and measuring devices, as well as auxiliary means:
- Tip -T10370-.
- Assembly tool -T10118-.
1. Remove the bottom protection of the engine compartment.
2. Unscrew the fastening screws (4), move engine cooling pump 2 -V178- (3) with hoses connected to the right side, as shown in the figure below.
3. Disconnect the wiring harness connector (1) from the engine speed sender -G28- with assembly tool -T10118- as shown in the figure below. Set the power cord aside.
Note. To release the cable harness connector without assembly tool -T10118-, press the release button on the connector with a screwdriver and at the same time unhook the release button with a thin wire hook.
4. Unscrew the fixing screw (arrow) Engine speed sender -G28-, pull out the sender as shown in the figure below.
Installation
1. Installation is made in reverse order to removal.