Removing
1. Push puller -T10094 A- onto the ignition coil with power output stage in direction (arrows), as shown in the figure below.
2. Slightly remove the ignition coil with the final power stage from the cylinder head.
3. Install assembly tool -T10118- as shown in the figure below.
4. Carefully release the harness connector retainer and disconnect the harness connector.
5. Remove the disconnected ignition coil with final power stage from the cylinder head.
Installation
1. Fit puller -T10094 A- on ignition coil with power output stage, insert it into bore in cylinder head.
2. Connect the wiring harness connector to the ignition coil with the final power stage so that it clicks into the locked position.
3. Press ignition coil with power end stage puller -T10094 A- onto spark plug in cylinder head.