Attention: Follow the rules of conduct at the gas station. Shut off the engine and ignition, turn off the auxiliary heater, and do not smoke when removing the fuel filler cap.
Caution: If the tank is filled with the wrong type of fuel, do not attempt to start the engine as this could damage the engine. The fuel supply system must be checked by a qualified person immediately.
The fuel filler cap is located behind the rear right door. The hatch cover is locked and unlocked together with a single lock (see section 1). To open the unlocked cover, push on its rear edge (left side of illustration 4.1), and then drag it.
4.1 Fixing the cork
Unscrew the filler cap and install it on the hatch cover (right side of illustration 4.1). On the inside of the hatch cover there is a sticker indicating the type of fuel to be filled. The type of fuel and the capacity of the fuel tank are also indicated in Specifications for Chapter 1.
Insert the filling nozzle into the filler neck of the tank so that it is constantly resting on the vehicle body, and start refueling. On early models, make sure the fuel nozzle does not press on the air valve in the neck, otherwise you may accidentally fill the space for fuel expansion. Stop refueling as soon as the fuel nozzle turns off for the first time, otherwise fuel may fill the tank expansion space and splash out. Before removing the filling nozzle, it is recommended to wait at least 10 seconds for the remaining fuel to drain into the fuel tank. Raise the gun slightly to remove the gun from the tank.
If necessary, add fuel from the canister to the tank, use a funnel.
Fuel spilled on the bodywork and wheels should be wiped off and washed off immediately.
Tighten the filler cap until it clicks into place, then close the filler cap and push it in.