General appearance
1. Sealing ring; 2. Dowel pin; 3. Fastening screw, tightening torque during installation 8 Nm; 4. Seal; 5. Mounting screw; 6. Intake manifold stand assembly; 7. Mounting screw; 8. Mounting screw; 9. Mounting pin; 10. Fastening screw, tightening torque during installation 8 Nm; 11. Intake manifold assembly with intercooler; 12. Mounting screw; 13. Intake air temperature sensor after intercooler, tightening torque of the sensor during installation 22 N·m; 14. Seal; 15. Connecting pipe; 16. Intake air temperature sensor, tightening torque of the sensor during installation 22 N·m; 17. Fastening screws, tightening torque during installation 10 Nm; 18. Water pipe; 19. Fastening screw, tightening torque during installation 10 N·m; 20. Cooling system hose; 21. Sealing rings; 22. Throttle body module assembly; 23. Sealing ring; 24. Air duct pipe; 25. Mounting bolt; 26. Mounting bracket; 27. Mounting screw; 28. Mounting screw.
Tightening torques for intake manifold mounting bolts
The mounting bolts are tightened in three stages:
- First approach: tighten the mounting bolts (1 - 10) by hand until they stop.
- Second approach: tighten the mounting bolts (1 - 10) with a tightening torque of 20 Nm.
- Third approach: tighten all mounting bolts an additional 90°.
Intake Manifold Strut and Throttle Module Mounting Bracket Bolt Tightening Torques
| Approach | Fastening bolts and nuts | Tightening torque |
| 1 | (2) (3) (4) (7) | Tighten by hand until snug |
| 2 | (2) (3) (4) (7) | Tighten to a torque of 20 Nm |
| 3 | (5) | Tighten to a torque of 10 Nm |
| 4 | (D | Tighten to a torque of 10 Nm |
Material is available on the website SkodaBook.ru
